Skip to content
LISEN BAUMER · Point Level Sensor
◎ EN
Request a quote

Testing & maintenance

Troubleshooting a switch that does not detect product

A Point Level Sensor supports the process only when its installed tip detects the intended material.

4 10 月 2026 · 3 minute read

POINT LEVEL SENSOR / PRACTICAL ADVANTAGE

Restore a useful product-present signal

A Point Level Sensor supports the process only when its installed tip detects the intended material. Structured checks of supply, output, position and medium response can identify what is preventing that signal. This helps retain the benefit of compact local detection without replacing parts on guesswork alone.

Verify coverage at the sensing region

Confirm that the medium reaches the active tip rather than stopping inside a nozzle or flowing past another part of the body. In bulk solids, a void or channel can leave the tip uncovered even when the vessel contains material.

A poorly wetted or low-dielectric product may require a different configuration or technology. Compare the actual medium with the suitability evidence used at purchase.

Check power and signal compatibility

Use the manufacturer’s diagram and qualified test procedures to confirm the supply and the receiving input. A local LED state and a PLC indication are not the same evidence. Check output type, logic, permitted load and the controller program before concluding that the sensing element has failed.

Retest in controlled conditions

Where permitted, compare clean air and a known representative product sample, then the actual process residue and temperature. Keep the results with the complete order code. If the device is damaged or the response cannot be made reliable within its documented capability, replace or reselect it rather than forcing an unsafe setting.

What to confirm for your application

  • Actual coverage at the active tip
  • Medium and temperature used for selection
  • Supply and output compatibility
  • Controller interpretation
  • Supplier review of damaged or unsuitable equipment

Distinguish contact, sensing and signal problems

Use a controlled reference condition to separate these questions. If the local indication changes during a representative test but the PLC does not, the primary problem may be integration. If neither changes, confirm supply and configuration before concluding that the principle is unsuitable. A successful water test is only one observation; oils, powders and aerated products can behave differently. Finish with the actual installation and the required operating sequence, and document what was changed.

Review item Meaning Action
Contact Does the intended material actually cover the active tip? Check trapped air, nozzle recess and intermittent flow.
Sensing Can this configuration separate the relevant medium states? Review the least favorable product and settings.
Signal Does the output reach a compatible input? Check supply, pin assignment and the electrical interface.

Explore the Point Level Sensor advantages guide or compare the available sensor families for this duty.

Put this Point Level Sensor advantage to work

Compare the Lisen and Baumer Point Level Sensor families, prepare an application brief, or use the sensor selector to organize the next technical discussion.

References

Baumer CleverLevel LBFS datasheet — supplied reference, EN/2018-03-01

Lisen technical reference — English summary of the supplied 2024-11-25 manual

Technical guidance. Verify the current order-code documentation and your plant requirements before applying a recommendation.

Continue reading

LISEN · BAUMER

Put Point Level Sensor advantages to work in your process.

Tell us the medium, switching task, temperature, pressure and connection. We will help define the sensor family and installation package.

Request a quote
Contact on WhatsApp
滚动至顶部